Filter
Top Products
5
Locking 5V DC Power Supply Input1
Connect the included 5V DC power supply to this input port.
HDMI Input Port2
Connect the HDMI source device to this input port. A secure connection to this
HDMI port can be made using Gefen Mono•LOK cables.
IR Out Port3
An IR emitter/blaster (sold separately, part# EXT-2IREMIT) must be connected
to this port to use the IR Repeater feature. Connect the emitter to this output port
and then connect the emitter “eye” on or near the IR receiver of the equipment
that is intended for control.
Link LED Indicator4
This LED indicator will become active once a valid link has been established
between the sending and receiving units. If this LED does not activate there is a
possible mis-connection between the two units.
Red BNC Connector5
This connector will transmit the RED signal data to the receiving unit. The cable
used for this connection cannot be omitted.
Green BNC Connector6
This connector will transmit the GREEN signal data to the receiving unit. The
cable used for this connection cannot be omitted.
Blue BNC Connector7
This connector will transmit the Blue signal data to the receiving unit. The cable
used for this connection cannot be omitted.
Clock BNC Connector8
This connector will transmit the CLOCK signal data to the receiving unit. The
cable used for this connection cannot be omitted.
Receiver Power BNC Connector9
This connector will transmit the power needed to operate the receiving unit. The
cable used for this connection can be omitted when using a 4 BNC type of cable
setup. If this cable is omitted power must separately be supplied to the receiver
by one of the included 5V DC power adapters.
SENDER PANEL DESCRIPTIONS