Filter
Top Products
- 7 -
English
6. Installation Directions
Anode
Figure a
Please read the following installation directions before using i-RAM:
Figure b
Figure c
Figure d
Each time before setting up the i-RAM, make sure to remove system power and
the i-RAM battery to prevent damage.
Hardware Installation
8-1 : Open the cover
Please remove the four screws on the cover
(Figure a ), then pull up the cover (Figure b).
8- 2: Install Memory Module(s)
Place i-RAM card on an anti-static pad.
The DIMM socket has a notch, so the memory
module can only fit in one direction. Push the
clips at both end of the DIMM socket outwards
to the open position(Figure c). Insert the memory
module into the DIMM socket. Then push it
down until the retaining clips snap into place
(Figure d). We recommend slotting memory
modules from the top socket.
Replace the i-RAM
battery after inserting the memory module(s).
8- 3: Install Battery
Please make sure that the battery is properly
installed to the battery socket. The 3 gold pins of
the battery should be at the same direction with
the battery socket pins direction.
8- 4: Install FAN connector
Please double check the 3-pin connector to the
CPU Fan connector on the motherboard.
8- 5: Close the cover
First place the cover over the i-RAM card and
make sure the card and screw hole are align
then fit in the base cover. Put in the screw once
the base cover and its screw hole are well
aligned.