Filter
Top Products
12
5. PREPARATION
Loading the Battery into the Camera
Please load the NP60 battery pack into the battery compartment according to following steps:
1. Slide the battery compartment cover open in the direction as indicated
2. Face the battery up with letter side upward. Follow the battery injection direction
according to the correct
polarity marks (+ or-) and plug the battery into camera
3. After the battery is properly installed, close the battery compartment door firmly
Note:
u Please fully charge Li-ion battery pack for at least three hours before using camera.
u If you remove the battery from the camera, you will need to set the date and time again the next time you
reinsert the battery and use the camera.
Inserting and Removing an SD Card (Not Supplied)
The video camera comes with 64 MB pre-build memory which allows you to store pictures, movies, recorded
voice. You can expand the memory capacity by using an optional SD or MMC memory card up to 512MB. To
insert a memory card, refer to the figure above and: