Filter
Top Products
Page 6
14540
LC-1000 Lube System Controller
Sample LC-1000 Program for Piston Distributor or Injector Systems
31 Point Piston Distributor System
DESCRIPTION
System Lube Volume: 99 cc (6.0 cu in) per hour
EO-3 Motor Driven Pump: 140 cc/min (8.5 cu in)
Total Piston Distributor Displacement: 4.62 cc/cycle
(.28 cu in)
Cycle Interval: 99 cc / 4.62 cc = 21.4 cycles/hr
60 min/21.4 cyc = 2.8 min (168 sec) per cycle
Cycle Switch (Pressure Switch) Transitions:
(1 transition/cycle) x 1 = 1
Pump Run Time: 4.62cc/140cc = .033min
(1.98 second)
Monitor Time: 1.98 sec x 2 (safety factor) = 3.96
seconds
Note: Due to the very short calculated pump run time,
use a 20 second monitor time.
■
■
■
■
■
■
■
■
PROGRAMMING
1. Initiate Programming Mode
a) Press “PRGM” Key – “ON” Icon blinks
2. “ON” (Monitor Period)
a) Press “ENTER” Key – ON TIME/COUNT blinks
b) Use S Key and X Key to set Monitor (“ON”)
Time to 0020
c) Press “ENTER” Key to accept value;
“SEC/MIN/HR/CNT” blinks
d) Use S Key to scroll through choices;
select ” SEC”
e) Press “ENTER” Key to accept choice;
“OFF” Icon blinks
3. “OFF” (Pause Time)
a) Press “ENTER” Key –
OFF TIME/COUNT blinks
b) Use S Key and X Key to set
“OFF TIME” to 0168
c) Press “ENTER” Key to accept value;
"SEC/MIN/HR/CNT" blinks
d) Use S Key to scroll through choices;
select “SEC”
e) Press “ENTER” Key to accept choice;
“CYCLE” Icon blinks
4. “CYCLE” (Pressure Switch Transitions)
a) Press “ENTER” Key; CYCLE blinks
b) Use S Key and X Key to select 01
(1 pressure switch transition = 1 system cycle)
c) Press “ENTER” Key to accept value;
”PUMP” Icon blinks
5. “PUMP ON” (Pump Duty-Pulsed/Non-Pulsed)
a) Press “ENTER” Key;
"PUMP" (pulsed on time) blinks
b) Use S Key and X Key to set
”ON TIME” TO 00 (non-pulsed output)
c) Press “ENTER” Key to accept value;
LCD returns to “DISPLAY” mode
Programming is now complete. To verify lube se-
quence, initiate a manual lube cycle by pressing
“Manual Run” button.
VENT
VALVE
PUMP AND
RESERVOIR
VENT LINE
LUBRICATION
POINTS
PISTON
DISTRIBUTORS
PRESSURE
SWITCH