Filter
Top Products
IMAGETEAM™ 2020/5620 System Manual 3 - 5
If there are no trigger pulls during the “scanner power time-out timer” interval, the
scanner goes in power down mode. Whenever the trigger is enabled, the
“scanner power time-out timer” is reset. If the scanner is placed in the IT2020-5
cradle and the battery is in the process of being charged, the scanner will not go
into power down mode.
Note: When the scanner is in power down mode, pull trigger to power the unit
back up. There will be a set of power up beeps and a delay of up to a few
seconds for the radio to join. The scanner will then be ready to use.
Automatic Trigger
The scanner scans continuously at full power with illumination fully on.
Presentation Mode
The LEDs are off until a bar code is presented to the scanner. Then the LEDs
turn on automatically to read the code. Presentation Mode uses ambient light to
detect the bar codes. If the light level in the room is not high enough,
Presentation Mode will not work properly.
Hands Free Time-Out
The Automatic Trigger and Presentation Modes are referred to as “hands free”
modes. If the imager’s trigger is pulled when using a hands free mode, the
imager changes to manual trigger mode. You can set the time the imager should
remain in manual trigger mode by setting the Hands Free Time-Out. Once the
time-out value is reached, (if there have been no further trigger pulls) the imager
reverts to the original hands free mode.
Scan the
Hands Free Time-Out
bar code, then scan the time-out duration (from
0-300,000 milliseconds) from the inside back cover, and
Save
.
Default = 5,000
ms.
Scanner Power Time-Out
Automatic Trigger
Presentation Mode
Hands Free Time-Out