Hasselblad Flextight 848 Scanner User Manual


 
Operating Instructions
(See Figure 4 opposite).
1. It is assumed that the scanner and FlexColor software have been
properly installed.
2. If not already done, turn the feed table (A) to normal position.
3. Press the red power button (F) on the front of the scanner to switch it
on. The green light (G) starts flashing. This means that no firmware
has been downloaded yet. It will be downloaded automatically later
when you first run the FlexColor program.
4. Turn on your computer and start the FlexColor program. The green
light (G) will stop flashing indicating that firmware has been
downloaded to the scanner.
5. Select the original holder (K) that matches your original:
For transparencies, choose one of the holders that has a square
hole in it. The original must completely fill the hole with no edges
showing. Also, no edges of the original must extend past the outer
edges of the holder.
The feed table (A) must be in normal position.
For reflectives, select the large A4/letter-size holder with the clear
plastic layer.
The feed table (A) must be in normal position.
For 35 mm slide frames use the optional 35 mm slide mount
holder.
The feed table (A) must be adjusted to horizontal position. This is
obtained by lifting the table slightly upwards while pushing it
gently into the scanner.
Please note that when scanning 35 mm slide frames in the 35 mm
slide mount holder it is recommended to use autofocus. See the
FlexColor Software Reference for details.
continues...
User's Guide - Flextight 848
Hardware Reference - Flextight 848
15
Operating Instructions
English