Filter
Top Products
Enable Virtual Serv-
ers
Check to enable virtual server function.
Servers You can set up a local server with specific port number
that stands for the service (e.g. web (80), FTP (21),
Telnet (23)). When this device receives an incoming
access request for this specific port, it will be forwarded
to the corresponding internal server. You can add virtual
servers by either port numbers or by names.
Maximum 24 Server entries are allowed and each port
number can only be assigned to one IP address.
Local IP Address Enter the Local Server’s IP address.
Protocol Select the protocol (TCP, UDP or Both) used to the remote
system or service.
Port Range For TCP and UDP Services, enter the beginning of the range
of port numbers used by the service. If the service uses a
single port number, enter it in both the start and finish fields.
Description You may key in a description for the local IP address.
Save
After completing the settings on this page, click Save to save
the settings.
Reset
Click Reset to restore to default values.