Filter
Top Products
PAR# = A decimal number or a character explained below:
1 : Station Address
2 : Multicast Address List
4 : Receive Packet Filter
5 : Retry Limit
6 : Save Bad Packet Flag
7 : Trace Mode Flag
8 : DSAP/CLASS number (program id) table
9 : Downloading Server Station Address
10 : File Server Station Address
11 : Card Status
A : [default] All of the above except for 2,8, and 11;
this PAR number only applies to RC command.
Option = A character explained below:
P Permanent configuration parameters – this option only
applies to the following parameters : (1,4,5,6,7,9)
These are card parameters stored in the NOVRAM. Card
parameters that are stored in the RAM as well as other
parameters stored by the NM are referred to as
’Temporary’ parameters.
T Temporary configuration parameters. [default]
DSAP = 2 hex digits that specify the Destination SAP. [no default value]
MSGLEN = a decimal number specifies the 802.3 information field length in
bytes from 0 to 1497. [default = 0]
Multicast Address = same syntax as ADR, an 802.3 address with LSB(bit)=1.
For example, in ADR=XY–XX–XX–XX–XX–XX, Y is one hex digit, and
the LSB(bit) of the 802.3 address is the LSB(bit) of Y, i.e. for ADR
to be a multicast address, Y must be odd. [no default value]
File–Address = same syntax as ADR, a link file identifier.
Must be an individual 802.3 address. [default to ADR]
PAR–Value = the new value of the parameter PAR#, applies to parameters:
1,4,5,6,7,9,10.
Default values: for parameters 1,9,10 – default to ADR,
for parameters 4,5,6,7 – default to 0.
Rep = Number of repetitions requested. The TC, EL, TEST, and XID commands
will repeat Rep number of times, or until failure, as a diagnostic
aid. The command may be aborted before completion by entering
’BR,NM’ from the CM> prompt. (An input value of Rep = 0 will loop
’infinitely’ until a failure occurs or ’BR,NM’ is input from the
CM> prompt.) The default value is Rep = 1.