HP (Hewlett-Packard) 2600 Series Switch User Manual


 
3-12
Web and MAC Authentication for the Series 2600/2600-PWR and 2800 Switches
General Setup Procedure for Web/MAC Authentication
Note on Web/
MAC
Authentication
and LACP
The switch does not allow Web or MAC Authentication and LACP to both be
enabled at the same time on the same port. The switch automatically disables
LACP on ports configured for Web or MAC Authentication.
General Setup Procedure for Web/MAC
Authentication
Note Web and MAC Authentication are available on these current ProCurve switch
models:
ProCurve Series 2600 and 2600-PWR Switches
ProCurve Series 2800 Switches
Do These Steps Before You Configure Web/MAC
Authentication
1. Configure a local username and password on the switch for both the
Operator (login) and Manager (enable) access levels. (While this is not
required for a Web- or MAC-based configuration, ProCurve recommends
that you use a local user name and password pair, at least until your other
security measures are in place, to protect the switch configuration from
unauthorized access.)
2. Determine which ports on the switch you want to operate as authentica-
tors. Note that before you configure Web- or MAC-based authentication
on a port operating in an LACP trunk, you must remove the port from the
trunk. (refer to the “Note on Web/MAC Authentication and LACP” on
page 3-12.)
3. Determine whether any VLAN assignments are needed for authenticated
clients.