Filter
Top Products
Monitoring and Analyzing Switch Operation
Traffic Mirroring
Syntax: show monitor < 1 - 4 | name < name-str >
Direction: For the selected interface, indicates whether mirrored
traffic is entering the switch (in), leaving the switch (out), or
both.
Displaying a Remote Mirroring Session. After you configure session 2
for remote mirroring (Figure B-35), you can enter the show monitor 2 command
to verify the configuration (Figure B-36).
ProCurve(config)# mirror 2 name test-10 remote ip 10.10.10.1 8010 10.10.30.2
Caution: Please configure destination switch first.
Do you want to continue [y/n]? y
ProCurve(config)# interface b1 monitor all both mirror 2
Figure B-35. Configuring a Remote Mirroring Session and Monitored Source
ProCurve_8200(config)# show monitor 2
Network Monitoring
Session: 2 Session Name: test-10
Policy: no policy relationship exists
Mirror Destination: IPv4
UDP Source Addr UDP port UDP Dest Addr Status
--------------- -------- --------------- -------
-
10.10.10.1 8010 10.10.30.2 active
Monitoring Sources Direction
If no monitored (source) interface is configured
------------------ ---------
for a mirroring session, no information is
displayed in the Monitoring Sources and
Port: B1 Both
Direction columns.
Figure B-36. Displaying the Configuration of a Remote Mirroring Session
Displaying a MAC-based Mirroring Session. After you configure a MAC-
based mirroring session (Figure B-37), you can enter the show monitor 3
command to verify the configuration (Figure B-38).
ProCurve(config)# mirror 3 port a1
ProCurve# monitor mac 112233-445566 src mirror 3
Figure B-37. Configuring a MAC-based Mirroring Session
B-80