Filter
Top Products
Using Integrated Lights-Out 100i 17
Command Action
SD[RRead]
Displays the Sensor Data Record
SEL[Read]
Displays the system event log
N[etwork setup]*
Sets up the network
R[eset] warm
Resets the server
R[eset] cold
Powers off the server and powers on
the server after a short time has
passed
V[ersion]
Shows the management firmware
version
H[ELP]
Displays a list of commands
Q[UIT]
Logs out of the remote management
card
* NOTE: Entering network setup to configure the network results in the command prompt
to INET>. For information on additional commands that can be entered at the INET>
prompt, refer to the "Using the system event log (on page 22
)" section.
Changing the password
The user password is stored in nonvolatile memory and can be changed through a
web browser ("Changing the password through a web browser" on page 17
) or
the CLI ("Changing the password through the CLI" on page 18
).
Changing the password through a web browser
1. Click User Configuration on the main menu navigation bar.