Filter
Top Products
802.1w Rapid Spanning Tree Protocol (RSTP) 802.1d Spanning Tree Protocol (STP)
802.1p Spanning-Tree Protocol (STP)
In this example, ports 2 and 3 have
already been configured as a port
trunk (Trk1), which appears at the end
of the port listing.
All ports (and the trunk) are in their
default STP configuration.
Note: In the actual menu screen, you
must scroll the cursor down the port
list to view the trunk configuration
(ports A2 and A3).
Figure 13-16. The Spanning Tree Operation Screen
4. On the ports and/or trunks you want to use for redundant fast uplink
connections, change the mode to
Uplink. In this example, port A1 and Trk1
(using ports A2 and A3) provide the redundant uplinks for STP:
a. Press
(for Edit), then enable STP on the switch by using the Space
bar to select
Yes in the Spanning Tree Enabled field.
b. Use to move to the Mode field for port A1.
c. Use the Space bar to select Uplink as the mode for port A1.
d. Use [v] to move to the Mode field for Trk1.
e. Use the Space bar to select
Uplink as the Mode for Trk1.
f. Press
to return the cursor to the Actions line.
13-34