Filter
Top Products
Hardware options installation 78
17.
Power up the server (on page 22, "Powering up and configuring the server" on page 40).
Expansion board options
The server supports up to ten PCIe expansion boards. For more information, see "System board components
(on page 13)."
IMPORTANT: The HP SAS Expander Card and the HP NC524SFP Adapter are not supported in
expansion slot 1.
To install the component:
1. Power down the server (on page 22).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 22).
o Extend the server from the rack (on page 24).
3. Remove the access panel (on page 25).
4. Remove fan 5 (on page 26).
5. If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 27).
6. Remove the air baffle (on page 28).
7. Open the expansion board retainer.