Filter
Top Products
RJ-11 jack cable
NOTE: The RJ-11 jack cable is included in the Cable Kit, spare part number 641830-001.
Before removing the RJ-11 jack cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 67), and then remove the following components:
a. Service cover (see
Service cover on page 69)
b. Smart Card reader (see
Smart Card reader on page 70)
c. Optical drive (see
Optical drive on page 71)
d. Hard drive (see
Hard drive on page 75)
e. Modem module (see
Modem module on page 84)
f. Keyboard (see
Keyboard on page 86)
g. Base enclosure (see
Base enclosure on page 91)
Remove the RJ-11 jack cable:
1. Turn the base enclosure right-side up, with the front toward you.
2. Release the RJ-11 jack from the clip (1) built into the base enclosure.
96 Chapter 4 Removal and replacement procedures