Filter
Top Products
46 Chapter 3
SSP operation
Using the console
Starting the console from the Workspace menu
To start the console using the Workspace menu, complete the following
steps:
Step 1. Move the pointer over the CDE workspace backdrop.
Step 2. Press and hold down any mouse button. The Workspace (root) menu
appears.
Step 3. Drag the mouse pointer to the “V-Class Complex: complex_name” option.
Step 4. Release the mouse button to select the option.
Step 5. Drag the mouse pointer to the Console option.
Step 6. Release the mouse button to select the option.
Step 7. Select the desired V2500/V2600 complex.
NOTE If the desired V2500/V2600 Complex name is not listed in the menu,
restart the Workspace manager. The desktop Workspace menus are
updated whenever a node is configured or deconfigured, but the new
menus are not activated until the Workspace Manager is restarted.
Step 8. Select Console menu.
Step 9. Select Node X/complex. The new console window appears.
Starting the console using the sppconsole command
This method of starting the console works from the SSP or after logging
on ot the SSP from another system.
To start the console using the sppconsole command, complete the
following steps:
Step 1. Select a shell window by placing the mouse pointer in the window.
Step 2. If more than one V-Class complex is connected to the SSP, use the
set_complex command to select the desired complex by entering:
set_complex.
An output similar to the following will be displayed. Enter the desired
complex from the list provided.