Filter
Top Products
Installing the HP UPS Power Protection Agent 35
• Change any items that should be unique, such as the Management Server IP address, through the
normal operation of the software.
To install the agent using the silent installation method:
1. Create a temporary directory.
2. Copy the following files into the temporary directory you just created:
o DevManRA.ini—During an assisted install, this file is landed in the same folder in which the
agent is installed.
o EULA.txt—This file is included with the installation files on the HP Infrastructure Management Pack
CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
o SetupRA—This file is included with the installation files on the HP Infrastructure Management
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
o Uninstall—This file is included with the installation files on the HP Infrastructure Management
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
o HPRA-4.5-x.i586.rpm—This file is included with the installation files on the HP Infrastructure
Management Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
3. From the directory that contains all five files, run ./SetupRA -s -f <path> DevManRA.ini to
install silently.
Replace <path> with the DevManRA.ini file location.
The following command line parameters can be specified and are applicable for both interactive and
silent modes.
Parameter Function
-s
Performs a silent install.
-log
Creates an installation log
(/user/local/DevMan/install.log). Default is
disabled for interactive mode and enabled for
silent mode. This option is supported only on Linux.
The installation log is created automatically for
Windows® during silent installations in
\%systemdrive%\setup.log.
-f DevManRA.ini
Specifies a configuration .ini file used for clean
installs. When this option is specified, the device
detection and configuration step is omitted.
Installing the agent on SLES 10
1. Install the agent using the Linux installation script ("Installing the agent using the installation script"
on page 33).
-or-
Install the agent using the Linux silent installation method ("Installing the agent using the silent
installation method" on page 34).
2. Do one of the following: