Filter
Top Products
Rack Air Duct kit 93
Installing the floor gasket
1. Cut the floor gasket at the perforation to reduce the length from 800-mm (31-in) to 600-mm (24-in).
2. Remove the protective tape from the bottom edge of the floor gasket, and then apply it to the bottom of
the rack with the adhesive strip facing the front of the rack.
Installation is complete.
Installing the Top Exhaust Extension kit
Follow these instructions to install the AF028A Top Exhaust Extension Kit, either to an AF030A Top Exhaust
Rack or after you have installed the AF029A kit to an existing HP retrofit rack.
1. Remove the rear doors and door hinges from the rear of your rack.
2. Install the rear extension assembly to your rack.
3. Install the solid rear doors to the extension assembly.