Filter
Top Products
2. Remove the 5 Mylar screw covers (1), the 4 Phillips screws (2), and the 2 Phillips PM2.0×6.0
screws (3) that secure the secondary hard drive cradle assembly to the computer.
3. Turn the computer right-side up, and open the display as far as possible.
4. Disconnect the secondary hard drive cradle assembly USB cable from the system board.
5. Release the USB cable from all obstructions (1) and tuck the excess cable and connector
securely into the cradle assembly (2).
NOTE: Be sure that the USB connector and cable are completely disconnected from the
system board and secured inside the cradle assembly before you remove the cradle assembly
from the optical drive bay.
68 Chapter 4 Removal and replacement procedures