Filter
Top Products
6. Slightly dampen the used cloth with 95% ethanol to wipe the remaining dry ink deposits from the
platen.
NOTE: 95% ethanol is not provided in the User Maintenance Kit.
CAUTION: Ethanol is highly flammable. Observe the manufacturer’s safety precautions.
CAUTION: Do not use commercial cleaners or abrasive cleaners. Do not wet the platen directly,
because you will leave too much moisture behind, which could damage the substrate advance
sensor.
7. Use the damp cloth to remove remaining dry ink deposits from the cutter ramp.
8. Use a dry cloth to clean the exposed part of the wheels. Ideally, you should clean the entire
circumference of these wheels.
9. Remove the 95% ethanol and the cloth from the vicinity of the printer.
10. Wait 3 or 4 minutes to let the ethanol evaporate, before turning on the printer and reloading the
substrate.
11. With a 1 mm diameter pin ensure that the vacuum holes are not obstructed, especially the holes
that are covered by the most-used substrate sizes.
ENWW
Clean the platen
17
Maintain hardware