Filter
Top Products
3. Pull the DIMM baffle straight up and out.
To replace the component, reverse the removal procedure.
DIMMs
The memory subsystem supports only DDR3 SDRAM technology using industry-standard 1.2” high
DIMMs.
BL890c i2 Min / Max
Memory size
BL870c i2 Min / Max
Memory size
BL860c i2 Min / Max
Memory size
Single DIMM
sizes
Not supportedNot supported8 GB / 48 GB2 GB
32 GB / 384 GB16 GB / 192 GB8 GB / 96 GB4 GB
32 GB / 768 GB32 GB / 384 GB16 GB / 192 GB8 GB
64 GB / 1.5 TB64 GB / 768 GB32 GB / 384 GB16 GB
CAUTION: When a single DIMM is removed it must either be replaced with a new matching
DIMM, or the DIMM load order must be adjusted.
1. Power off the server blade and remove it from the server blade enclosure (“Preparing the
server blade for servicing”).
2. Remove the access panel (“Access panel” (page 113)).
3. Locate the DIMM slots on the server blade system board (Step 2.
4. Remove the DIMM baffle (“DIMM baffle” (page 115)).
5. Open the DIMM slot latches.
116 Removing and replacing components