Filter
Top Products
Troubleshooting
Error Messages and Event Logs
Chapter 4
58
Error Messages and Event Logs
Server firmware and management features monitor system operation, report errors, and log all significant
events. This section presents error message and log information. Refer to the hp Integrity cx2600 Operation
and Maintenance Guide for additional information and instructions to access error messages and logs.
Power Supply
DC Out
Green Lit when a power supply is operating normally. Indicates that DC
power is being supplied to server circuits.
Power Supply
DC In
Green Lit when power (–36 to –72 VDC) is being supplied to the power
supply. Indicates that source power is available.
Gigabit LAN Gbit LED
(top)
Green When off, no 1000 Mbps link has been detected.
When lit, port is linked at 1000 Mbps.
Gigabit LAN 100 Mbit
LED (2nd from top)
Green When off, no 100 Mbps link has been detected.
When lit, port is linked at 100 Mbps.
Gigabit LAN Link LED
(2nd from bottom)
Green When off, no 10 Mbps link has been detected.
When lit, port is linked at 10 Mbps.
Gigabit LAN Activity
LED (bottom)
Green When off, no LAN activity has been detected.
When lit, port is linked at 1000 Mbps.
Management Processor
Self Test LED (top)
Green When off, self test is not active.
When lit, MP is running self test.
Management Processor
10BT LED (2nd from
top)
Green When off, no link detected or 100BT link is active.
When flashing, indicates 10BT LAN activity.
When lit steady, indicates that 10BT link has been established.
Management Processor
100BT LED (2nd from
bottom)
Green When off, no link detected or 10BT link is active.
When flashing, indicates 100BT LAN activity.
When lit steady, indicates that 100BT link has been established.
Management Processor
LAN Standby Power
LED (bottom)
Green When off, standby power is not applied to Management LAN circuits.
When lit, power is connected to the server but the server is not on.
Table 4-4 Rear Panel LED Definitions (Continued)
LED/
Button
Color Description