Filter
Top Products
Service Reference Guide, dc7600 390742-001 8–7
Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis
8.6 Front Panel Assembly
1. Prepare the computer for disassembly (Section 8.1).
2. Remove the computer access panel (Section 8.3).
3. Remove any MultiBay device from the drive cage (Section 8.4).
4. Remove the MultiBay riser card (Section 8.5).
5. Lift up on the two green locking levers on the left and right sides of the chassis 1. This will
unlatch the front panel assembly and push it about 1.3 cm (1/2 inch) out
of the chassis.
6. Disconnect the fan and speaker cables from the system board and remove the panel
assembly
2 by pulling it straight out of the chassis.
To reinstall the front panel assembly, reverse the removal procedure.