Filter
Top Products
Power connector cable
Description Spare part number
Power connector cable 719859-001
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 46), and then remove the following components:
a. Optical drive (see
Optical drive on page 47)
b. Hard drive (see
Hard drive on page 49)
c. WLAN module (see
WLAN module on page 51)
d. Keyboard (see
Keyboard on page 56)
e. Top cover (see
Top cover on page 60)
f. RJ-45/USB board (see
RJ-45/USB board on page 91)
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable from the clips (2) built into the base enclosure.
92 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts