Filter
Top Products
:TTLTrg<
n
>[:STATe]
OUTPut:TTLTrg<n>[:STATe] <mode> enables or disables routing of the
synchronization pulse to the specified VXIbus TTL trigger lines (TTLTRG0*
through TTLTRG7*).
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
n
numeric 0 through 7 none
mode
boolean OFF|0|ON|1 none
Comments • Executable when initiated: No
• Coupled Command: Yes. This command will cause a settings conflict error if
the same TTL trigger line is used in any of the following:
ARM:STARt:SOURce1, ARM:STARt:SOURce2 or TRIG:STARt:SOURce.
• Unlike the ECLTRG trigger lines, the TTLRG trigger lines are not independent
with regard to FEED. All TTLTRG triggers enabled will be outputting the same
synchronization signal specified by the OUTPut:TTLTrg<n>:FEED command.
• Routing synchronization pulses to the TTLTRG trigger lines is independently
enabled/disabled for each line.
• *RST Condition: OUTPut:TTLTrg<n>:STATe OFF
Example Enabling sync pulse output to TTLTRG0* and TTLTRG5*
OUTP:TTLT0 ON Enable TTLTRG0*
OUTP:TTLT5 ON Enable TTLTRG5*
OUTPut:TTLTrg<
n
>[:STATe]
248 Command Reference OUTPut Subsystem