Filter
Top Products
Display assembly components (panel, bezel, webcam, microphone)
All display assemblies include WLAN antenna transceivers and cables. WWAN models also include 2
WWAN antenna transceivers and cables.
Full hinge-up displays are not spared.
This section describes removing components that do not require that you entirely remove the display
assembly from the computer. You can remove the display bezel, webcam/microphone module, and
display panel with the display assembly still attached to the computer.
To remove the remaining display components, including the display brackets, antennas, and
enclosure, you must remove the entire display assembly from the computer. See
Display assembly
on page 76 for more information about removing the remaining components.
Description Spare part number
Display panels
35.6-cm (14.0-in), HD+, anti-glare, LED 708771-001
35.6-cm (14.0-in), HD anti-glare, LED 702871-001
Display bezels
For use with models with a webcam 702860-001
For use with models without a webcam 702861-001
Webcam module with microphone 702854-001
Microphone module 702873-001
Before removing the display panel, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 40).
Remove the display assembly components:
1. Position the computer upright, with the front toward you.
2. Open the computer as far as possible.
3. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Flex the inside edges of the bottom edge (1), the left and right sides (2), and the
top edge (3) of the display bezel until the bezel disengages from the display enclosure.
42 Chapter 4 Removal and replacement procedures