Filter
Top Products
10
PCI_MUL.DUT and PCI.ADP from your PCI Scope
Preprocessor diskette to that directory.
3. Access the configuration menu of the MultiProbe Control
card.
4. Select POD setup for the POD that will be connected to the
Scope Preprocessor.
5. On the next menu select #2 Specify POD adapter and then
select the file PCI.ADP and select proceed.
6. Return to the MultiProbe Configuration menu and Select
Assign Signal Names
7. From the File selection menu select the MULTIPRB directory
on the hard disk.
6. Select the field next to File.
Select the file PCI_MUL.DUT
7. Load the file
With PCI_MUL displayed in the File field, select Load
File.
Once you have completed loading these two files the PCI Scope
Preprocessor is ready for PCI analog analysis and the
configured POD in the MultiProbe configuration menu will
appear as below
For further information on the operation of the MultiProbe
Control Card refer to the HP 16535A MultiProbe Users Guide.
The operation of the PCI Scope Preprocessor is independent of
the Oscilloscope that is attached to the MultiProbe Control Card.
Refer to the HP 16535A MultiProbe Control Users Guide for
information on how to attach to the Oscilloscope.
Connecting the
MultiProbe Control Card
to an Oscilloscope