Filter
Top Products
15
General Information
This chapter provides additional reference information including
the characteristics and signal connections for the PCI Scope
Preprocessor module.
The following operating characteristics are not specifications,
but are typical operating characteristics for the PCI Scope
Preprocessor module.
32/64 bit PCI Local bus accepting the short card length and
universal connector pinout. All PCI local bus ground pins of the
universal board pinout are connected to the ground plane of the
PCI Scope Preprocessor module.
The PCI Scope Preprocessor does not implement JTAG
Boundary SCAN. Pins TDI and TBO (pins 4a and 4b) are
connected together so the scan chain is not broken.
No connection is made to the PCI signals PRSNT1# and
PRSNT2#.
The PCI Local Bus Specification Revision 2.1
The PCI Scope Preprocessor contains no active components
and therefore requires no power.
The PCI Scope Preprocessor requires one 208 pin MultiProbe
Pod with the option 101 personality adapter.
Per the PCI Local Bus Specification the PCI Scope
Preprocessor presents only one electrical load on each PCI bus
signal. The PCI Scope Preprocessor is designed to present a
worst case load (10pf) at the maximum stub length. For
Characteristics
Preprocessor Interface
Compatibility
JTAG Boundary Scan
The PCI Present Pins
Standards Supported
Power Requirements
MultiProbe Pods
required
Signal loading