Filter
Top Products
1-13
Installing the Switch 208/224
Installation Steps
Installing the Switch 208/224
6. Connect the Network Cables
Using RJ-45 Connectors (10 Mbit/s and 100 Mbit/s ports)
100Base-T Xcvr Slot
An optional 100Base-T transceiver module can be installed in the switch’s
transceiver (Xcvr) slot to provide additional connectivity choices, including:
See the documentation accompanying the optional transceiver modules for
cabling configurations for those modules.
To connect:
until the tab on the plug clicks into place.
Push the RJ-45 plug into the RJ-45 jack
To disconnect:
Press the small tab on the plug and
pull the plug out of the jack.
RJ-45 plug
Unshielded twisted-pair cable:
When power is on for the switch and the
Category 3, 4, or 5 for 10 Mbit/s ports
Cat 3, 4 maximum distance: 100 meters
Cat 5 maximum distance: 150 meters for 10BT
connected device, the Port LED should
light to confirm a powered-on device
end of the cable.
(for example, an end node) is at the other
Category 5 only for 100 Mbit/s ports
Caution:
Do not connect a 10 Mbit/s network
into either of the 100 Mbit/s ports.
100 meters for 100BT
HP 100Base-FX Fiber-Optic Transceiver Module
(HP J3193B)
Maximum Distance: 1 kilometer
HP 100Base-TX Twisted-Pair Transceiver Modul
e
(HP J3192B)
Category 5 maximum distance: 100 meters
YUMABOOK.BK : 1_instal.fm5 Page 13 Thursday, February 20, 1997 9:35 AM