HP (Hewlett-Packard) 4500 Printer User Manual


 
EN
Chapter 6 107
9 If you keep BOOTP=YES *, the values for the TCP/IP parameters
will be provided by the BOOTP file, RARP, or DHCP and no other
TCP/IP configuration is necessary. Skip to step 17.
– OR –
Press V
ALUE
to change the value of the BOOTP= parameter.
BOOTP=NO displays.
10 Press S
ELECT
to save the selection. BOOTP=NO * appears, and
you are prompted to configure each of the TCP/IP parameters.
11 Press I
TEM
to continue configuring. IP BYTE 1=<value>> *
displays.
12 Press V
ALUE
until the value of the first byte of the IP address
displays.
13 Press S
ELECT
to save the value.
14 Repeat steps 12 and 13 to configure the remaining bytes of the IP
address.
15 Press I
TEM
to continue.
16 Repeat steps 12-15 to configure the subnet mask bytes (SM),
default gateway (GW), and timeout (TIMEOUT).
17 If you are finished, press G
O
to return the printer to the READY
state.
– OR –
See the appropriate sections for other protocols that will be used.
To configure Apple EtherTalk parameters from the
printer control panel
1 Press M
ENU
until HP EIO 1 MENU displays.
2 Press I
TEM
until CFG NETWORK=NO * displays.
3 Press V
ALUE
until CFG NETWORK=YES displays.
4 Press S
ELECT
once. CFG NETWORK=YES * displays.