Filter
Top Products
Fast!UTIL
45FCA2214/FCA2214DC PCI-X Host Bus Adapters for Linux, NetWare, and Windows Installation
Guide
Selectable Boot Settings
This option enables you to select the node name from which you want to boot.
Once enabled, this option forces the system to boot on the selected FC hard disk,
ignoring any IDE hard disks attached to your system. If you disable this option,
the system looks for a boot device (as selected in the system BIOS). In disabled
mode, the Boot ID and Boot LUN parameters have no effect.
Some new system BIOS support selectable boot, which supersedes the Fast!UTIL
selectable boot setting. To boot from an FC hard disk attached to the HBA, select
the HBA Fibre Channel hard disk on the system BIOS.
Note: This option applies only to hard disks; it does not apply to tape drives and other
nondisk devices.
Restore Default Settings
This option restores the HBA default settings.
Raw NVRAM Data
This option displays the adapter’s NVRAM contents in hexadecimal format. This
is a troubleshooting tool; you cannot modify the data.
Advanced Adapter Settings
From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter
Settings. Table 7 lists the default settings for the HBA:
Table 7: Advanced Adapter Settings
Setting Options Default
Execution Throttle 1–256 16
Fast Command Posting Enabled, Disabled Disabled
4GByte Addressing Enabled, Disabled Disabled
Luns per Target 0, 8, 16, 32, 64, 128, 256 128
Enable LIP Reset Yes, No No
Enable LIP Full Login Yes, No Yes
Enable Target Reset Yes, No Yes