Filter
Top Products
NOTE: The smh command is available only in HP-UX 11i v3 February 2007 release and later.
The procedures in this section are applicable to HP-UX 11i v3 systems. In HP-UX 11i v1 and
HP-UX 11i v2 systems, the sam command remains the primary interface.
Starting HP SMH GUI
Follow this procedure to open the HP SMH GUI using the smh command:
1. Log in to the system.
2. Set the DISPLAY environment variable.
3. At the command prompt, enter sam or smh.
The application opens in the default web browser.
Follow this procedure to open the HP SMH GUI using a web browser:
1. Open a web browser.
2. In the address bar, enter the complete host name and the port number, for example,
http://hostname.com:2301
3. Log in to HP SMH GUI by entering your user name and password.
Starting HP SMH TUI
Follow this procedure to open the HP SMH TUI:
1. Log in to the system.
2. At the command prompt, enter sam or smh.
The SMH TUI opens.
Text-based HP SMH supports only the C (English) locale. HP recommends that you set your
locale variables, such as LANG and LC_ALL, to C. Most functional areas in web-based HP SMH
support multi-byte locales.
HP SMH Home Page
The HP SMH home page displays information about the health of the system. The page also
provides links under System Configuration to open few of the plug-ins (functional areas)
supported by the application, links under Operating System for information about operating
system, links under Software to obtain information about software products and bundles installed
on the system. Figure 1-1 (page 11) shows an image of SMH Home page on an HP-UX system.
10 HP System Management Homepage (HP SMH)