Filter
Top Products
Gigabit Ethernet lanadmin Display
RFC 1213 MIB II
Appendix A
56
RFC 1213 MIB II
Following are descriptions of the statistics fields in the lanadmin(1M) command display.
For more detailed information about the fields, refer to RFC 1213.
Field Description
Network Management ID A unique ID assigned by the system for the network
management of each network interface.
PPA Number A unique number assigned to each network interface,
distinct from NMID.
Description A textual string containing information about the
interface.
Type (value) The type of interface, distinguished according to the
physical/link protocols, immediately below the
network layer in the protocol stack.
Gigabit Ethernet can have one of the following
values: ethernet or IEEE 802.3.
MTU Size The size of the largest datagram which can be
sent/received on the interface specified in octets. This
value can be 1500 or 9000.
Speed in bits per second The speed of the card — 1000 Mbps for 1000Base-SX
and 10, 100, or 1000 Mbps for 1000Base-T.
Station Address The interface address at the protocol layer
immediately below the network layer in the protocol
stack. For interfaces which do not have such an
address, such as serial line, this object contains an
octet string of zero length.
Administration Status The status of the card. This parameter is set to up(1)
and is not configurable. It will have one of the
following values:
Operation Status The status of the link. This value is the same as the
administration status. If the value is up, the link is
operational.
Last Change The value of SysUpTime at the time the interface
entered its current operational state. If the current
state was entered prior to the last reinitialization of
the local network management subsystem, then this
object contains a zero value.
up(1) Ready to pass packets
down(2) Not operative
testing(3) In test mode