Filter
Top Products
Hardware Regulatory Statements
Laser Safety Statements
Appendix D
74
Laser Safety Statements
Laser Safety Statements - U.S. FDA/CDRH - Optical (laser) Transceiver
CAUTION The optical transceiver provided on the network interface card contains a laser system
and is classified as a “Class-I Laser Product” under a U.S. Department of Health and
Human Services (DHHS) Radiation Performance standard according to the Radiation
Control for Health and Safety Act of 1968. The Class I label and compliance statement
are located on the optical transceiver.
To ensure proper use of this product, please read this instruction manual carefully and
retain for future reference. Should the unit ever require maintenance, contact an
authorized service location.
CAUTION Use of controls, adjustments or the performance procedures other than those specified
herein may result in hazardous radiation exposure. To prevent direct exposure to laser
beam, do not try to open the enclosure.
Laser Safety - European Union - Optical Transceiver Only
CAUTION The optical transceiver provided on the network interface card contains a laser system
and is classified as a “Class 1 Laser Product” per EN 60825-1, Safety of Laser products.
Class 1 laser products are considered safe and do not pose a biological hazard if used
within the data sheet limits and instructions.
To ensure proper use of this product, please read this instruction manual carefully and
retain for future reference. Should the unit ever require maintenance, contact an
authorized service location.
CAUTION Use of controls, adjustments or the performance procedures other than those specified
herein may result in hazardous radiation exposure. To prevent direct exposure to laser
beam, do not try to open the enclosure.
There are no user serviceable parts nor any maintenance required for the optical
transceiver. All adjustments are made at the factory before shipment to customers.
Tampering with or any attempt to modify the optical transceiver will result in voided
product warranty. It may also result in improper operation of the network card circuitry
and possible overstress of the laser source. Device degradation or product failure may
result.