Filter
Top Products
3 Connecting to a Windows NT Server 3.51
Windows 95 SR2
Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2.
• Intel EtherExpress PRO ISA ethernet card and drivers disk Ver. 2.3.
• Driver Name: El90X.DOS Size: 45KB Date: 3/21/97
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI,TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• I/O Address 350 - 35Fh
• Interrupt IRQ 10
• Board Connector type Auto-detect
• Force 8-bit operation Yes
• Flash chip address Disabled
• Remote boot program None
Procedure
1 With the HP Vectra turned off, install the Intel EtherExpress PRO ISA
adapter card into an ISA slot.
2 Connect network cable media to the Intel EtherExpress PRO ISA card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the Intel EtherExpress drivers disk, “EtherExpress
drivers Ver. 2.3.”, and execute “A:\SOFTSET2.EXE.”
5 Select “Configure NIC”, and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the Intel EtherExpress software driver diskette and reboot the
machine.
8 Power on the machine and allow it to boot to Windows 95.
9 When Windows 95 restarts, a message will appear that new hardware has
been found.