3 Connecting to a Windows NT Server 3.51
Windows NT Workstation Version 3.51
Windows NT
Workstation
Version 3.51
Requirements
• HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
• Intel EtherExpress PRO ISA Ethernet card and drivers disk Ver. 2.3.
D r i v e r N a m e : E P R O . S Y S S i z e : 1 0 7 K B D a t e : 7 / 1 8 / 9 6
• Microsoft Windows NT Workstation 3.51 and Service Pack Media.
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
IP,NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• I/O Address 350 - 35Fh
• Interrupt IRQ 10
• Board Connector type Auto-detect
• Force 8-bit operation Yes
• Flash chip address Disabled
• Remote boot program None
Procedure
1 With the HP Vectra turned off, install the Intel EtherExpress PRO ISA
Ethernet adapter card into an ISA slot.
2 Connect network cable media to the Intel EtherExpress PRO ISA
ethernet adapter card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the Intel EtherExpress drivers disk Ver. 2.3.” and
execute “A:\SOFTSET2.EXE.”
5 Select “Change Adapter configuration” and verify the resource settings
listed above under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the Intel drivers diskette and reboot the machine.
8 After windows loads, go to the “MAIN” program group , and double-click
on “Control Panel.”