Filter
Top Products
Change default copy settings
To set default copy settings from the control panel
1 Make any needed changes to the settings in the Copy Menu.
2 Press 9 to select Set New Defaults from the Copy Menu.
3 Press OK to accept the settings as the new default settings.
The settings you specify here are only saved on the HP all-in-one itself. They do not
adjust the settings in the software. You can save your most frequently used settings by
using the HP Image Zone software that came with your HP all-in-one. For more
information, see the onscreen HP Image Zone Help.
Make multiple copies of the same original
You can set the number of copies that you want to print by using the Number of
Copies option in the Copy Menu.
To make multiple copies of an original from the control panel
1 Make sure you have paper loaded in the paper tray.
2 Load your original face down on the right front corner of the glass.
3 Press Copy Menu, and then press 1.
This displays the Copy Menu and then selects Number of Copies.
4
Press
or use the keypad to enter the number of copies, up to the maximum, and
then press OK.
(The maximum number of copies varies by model.)
Tip If you hold down either of the arrow buttons, the number of copies changes by
increments of 5 to make it easier to set a large number of copies.
5 Press Start Copy Black or Start Copy Color.
In this example, the HP all-in-one makes six copies of the original 10 by 15 cm (4
by 6 inch) photo.
Copy a two-page black-and-white document
You can use the HP all-in-one to copy a single- or multiple-page document in color or
black and white. In this example, the HP all-in-one is used to copy a two-page black-
and-white original.
Chapter 7
52 HP PSC 2350 series all-in-one
Use the copy features