Filter
Top Products
Installing the HP UPS Power Protection Agent 36
o
Edit the /etc/sysconfig/boot file and change RUN_PARALLEL="yes" to
RUN_PARALLEL="no" to remove parallel script execution.
-or-
o Edit the /etc/init.d/.depend.start file and add DevMan: network at the end of the
file to add parallel information for DevMan.
Installing the agent on an Itanium system
1. Install the ia32* file for your operating system from the supplementary disc.
2. Install the appropriate library files for your operating system from the compact layer in the following
order:
a. Install the glibc* library file.
b. Install the zlib* library file.
RH4-U3 RH4-U4 RH4-U5 RH5
ia32* ia32el-1.3-2.ia64.rpm ia32el-1.3-2.ia64.rpm ia32el-1.3-2.ia64.rpm ia32el-1.6-
13.el5.ia64.rpm
glibc* glibc-2.3.4-
2.19.i686.rpm
glibc-2.3.4-
2.25.i686.rpm
glibc-2.3.4-
2.36.i686.rpm
glibc-2.5-12.i686.rpm
zlib* zlib-1.2.1.2-
1.2.i386.rpm
zlib-1.2.1.2-
1.2.i386.rpm
zlib-1.2.1.2-
1.2.i386.rpm
zlib-1.2.3-3.i386.rpm
3. Install the agent using the Linux installation script ("Installing the agent using the installation script"
on page 33).
-or-
Install the agent using the Linux silent installation method ("Installing the agent using the silent
installation method" on page 34).
Reconfiguring the agent on Linux operating systems
To configure the management module IP address or serial path for Red Hat Linux, run
/etc/rc.d/init.d/DevMan setup.
To configure the management module IP address or serial path for SUSE Linux Enterprise Server, run
/etc/init.d/DevMan setup.
Installing the agent on HP-UX operating systems
The UPS Power Protection Agent can be installed using an installation script, SAM, or silent installation
option on any supported HP-UX operating system.
IMPORTANT: To ensure your system has the minimum requirements needed to run the agent,
see "UPS Power Protection Agent requirements ("HP UPS Power Protection Agent requirements"
on page 8)."