Filter
Top Products
Figure 27 Cable Management Arm
WARNING! To avoid risk of injury or damage to the equipment, do not stack anything on top
of rail-mounted equipment or use it as a work surface when it is extended from the rack.
CAUTION: Always plan the rack layout before installing the equipment. See HP 3PAR StoreServ
7000/7450 Cabling Configuration Guide for the best practices for node and drive enclosure
positioning in specific configurations.
To install the rail kit and service processor:
1. Adjust the length of the mounting rails.
2. Install the threaded-hole cage nuts and rail mounting pins into the rack hole positions where
you want to install the component. Use two cage nuts and two rail mounting pins on the front
of each rail, and two cage nuts and two rail mounting pins on the rear of each rail.
Installing the Service Processor in the Storage System 29