Filter
Top Products
5. Remove the Torx T15 screw that secures the assembly to the front of the chassis.
6. Rotate the right side of the assembly away from the chassis.
Figure 6-30 Removing the front I/O, USB, power switch assembly
7. Pull the assembly toward the right and away from the chassis while threading the wires through
the slot between the drive cage and chassis front and the hole in the front of the chassis.
To reinstall the assembly, reverse the removal procedure.
NOTE: When reinstalling the cables, route the blue cable through the top hard drive cage slot and
route the green and yellow through the bottom hard drive cage slot.
106 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis