Filter
Top Products
2. Insert screws through the rack into the mounting rail and
the front of each mounting bracket.
3. Install cage nuts or clip nuts into the rear of the rack.
4. Insert screws through the mounting rail into the cage nuts
or clip nuts.
5. Tighten the hex nuts.
Preparing the rails for
integrated shipping
If the unit is to be shipped in an HP 9000 or
10000 series rack:
1. Remove the hex nuts, flat washers, and lock washers
from the mounting rail.
2. Install the rail reinforcement plates and tighten using the
hex nuts with captive washers included in the kit, instead
of the nuts included with the rail.
3. Install the rear mounting brackets using hex nuts. Wait
until the unit is installed and the brackets are adjusted
before tightening the nuts.