Filter
Top Products
RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
30
If the status menu fails to appear, ensure the
correct cables and adapters are being used
and that they are connected properly. Also,
verify the serial communication parameters
are correctly configured.
Controlling Receptacles
To set or change the status of receptacles,
enter one of the following commands: ON
n, OFF n, REBOOT n, where “n” is the
outlet number you want to command.
Entering an outlet number of “0” sends the
command to
all
outlets.
Example: To turn “On” Outlet 3, type
ON 3
from the
RPC prompt (RPC >). The RPC responds:
Turn On Outlet 3 (Y/N)?
Responding “Y” for yes turns “On” Outlet 3.
Observe that the status of Outlet 3 has
changed to
On
in the status menu:
RPC-2 Series
(c) 1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : On
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
Likewise, typing
ON 0
at the RPC > prompt
and responding “Y” for yes, turns “On” all
outlets. Typing
OFF n
at the RPC > prompt
turns off corresponding outlet(s).