Filter
Top Products
Figure 4 The Volume Security Window
DescriptionItem
Displays the security, host, and LDEV groups assigned to each LDKC defined on the
storage system. For details see “Security Group Tree ” on page 16.
Security Group tree
Displays the type, model, SEQNUMBER, Logical Partition (LPAR) and vendor of each
host. For details, see “Hosts Table” on page 18.
Hosts table
Allows you to select the desired command unit(s) available in each group. When you
select a CU image, the table below shows a list of volumes in the selected CU image
CU list
Shows the LDEV, emulation, and attribute information assigned to each logical device
on the storage system. For details, see “LDEVs Table ” on page 19.
LDEVs table
Applies the requested XRC setting changes to the storage system. Any change made to
a volume appears in blue italics until you click Apply.
Apply
Discards the requested changes without applying them to the storage system. A confirm-
ation message appears to allow you to cancel the requested operation(s). Click OK on
the confirmation message to cancel the requested operation(s), or click Cancel to keep
(but not start) the requested operation(s).
Cancel
Security Group Tree
Figure 5 shows the Security Group tree where you can select the LDKC (logical disk controller), and
then choose a security group, host group, or LDEV group residing on that LDKC.
When you double-click LDKC:00 or LDKC:01, you can display a list of security groups, host groups,
and LDEV groups in that LDKC. Once you have selected the LDCK you can choose from these options:
Using the Volume Security GUI16