Filter
Top Products
DescriptionItem
Provides information about a host, where the number groups, from left to right, indicate:
• First: The Type/Model the type and model number of a host (or a channel extender).
• Second: The Node ID of a host (or a channel extender).
• Third: The Logical Partition Number of the host.
• Fourth: The vendor of the host. Vendors include: FJT (Fujitsu), IBM, HTC (Hitachi), and
CNT(Ex). If CNT(Ex) appears, the table row indicates the type, model number, and
node ID of a channel extender.
Host
Specifies a host group that you want to register in the security group.Host Group
Lists security groups in which the specified host is registered.
• Security Group indicates the name of a security group.
• Security indicates whether the security settings in the security group are enabled or
disabled.
• Group Status indicates whether the security group is an access group or a pool group.
• T-VOL/R-VOL indicates whether volumes in the security group can be used as secondary
volumes (i.e., copy destination volume). Enable indicates the volumes can be used as
secondary volumes. Disable indicates the volumes cannot be used as secondary volumes.
Security Group
table
Closes the dialog box.OK
The Host to LDEV Dialog Box
The Host to LDEV dialog box (Figure 16) appears when you do either of the following in the Volume
Security window (Figure 4):
• when you right-click a host from the upper-right table and then select Host to LDEV from the pop-
up menu.
• when you right-click an item in the tree view and then select List -> Host to LDEV from the pop-up
menu. The List -> Host to LDEV pop-up command does not display if you double-click a security
group and then right-click a host group or LDEV group from immediately below the security group.
This dialog box enables you to specify a host and then displays volumes in the security group in which
the host is registered (see
“Locating Volumes in a Security Group that Contains a Specified Host” on page 44).
Using the Volume Security GUI34