Filter
Top Products
1–16 HP Integrity rx2600 server and HP workstation zx6000 Getting Started Guide
Setting Up and Using Your System
To access the EFI remotely:
1. With the workstation turned off, connect the serial cable provided
with your system (HP part number 5182-4794) or a compatible
cable to Serial Port A on the rear panel of the workstation, and to
your remote device.
2. Configure the terminal emulation software with these settings:
❏ Baud rate: 9600
❏ Bits: 8
❏ Parity: None
❏ Stop Bits: 1 (one)
❏ Flow Control: XON/XOFF
3. Using the terminal emulation software, connect to the
workstation with a direct connection.
NOTE: The default terminal emulation type is VT100+. This setting
can be changed from the EFI Boot Options Maintenance Menu.
4. Turn on the workstation and follow the steps below to access
the EFI.