Hitachi CP-RX79 Projector User Manual


 
16
Operating
Adjusting the projector's elevator
When the place to put the projector is slightly uneven to the left or right, use the
elevator feet to place the projector horizontally.
Using the feet can also tilt the projector in order to project
at a suitable angle to the screen, elevating the front side of
the projector within 12 degrees.
This projector has 2 elevator feet and 2 elevator knobs. An elevator foot is
adjustable while pulling up the elevator knob on the same side as it.
1.
Holding the projector, pull the elevator knobs up to loose the elevator feet.
2.
Position the front side of the projector to the desired height.
3.
Release the elevator knobs in order to lock the elevator feet.
To loose an elevator foot,
pull up the elevator knob
on the same side as it.
To nely adjust, twist the foot.
4.
After making sure that the elevator feet are locked, put the projector down
gently.
5.
If necessary, the elevator feet can be manually twisted to make more precise
adjustments. Hold the projector when twisting the feet.
Do not handle the elevator buttons without holding the
projector, since the projector may drop down.
Do not tilt the projector other than elevating its front within 12 degrees using
the adjuster feet. A tilt of the projector exceeding the restriction could cause
malfunction or shortening the lifetime of consumables, or the projector itself.
CAUTION
1.
Use the zoom ring to adjust the screen size.
2.
Use the focus ring to focus the picture.
Adjusting the zoom and focus
Focus ring
Zoom ring
51