Filter
Top Products
47
3. Management with Web browser software
3.7.2 Communication setup
3.7.3 Communication port
1) Using the SERIAL OUT SETTING menu, select the proper baud rate and
parity for the
CONTROL OUT
CONTROL OUT port, according to the specifi cation of the RS-
232C port of the connected device. (
Operating Guide - OPTION menu
- SERVICE – COMMUNICATION – SERIAL IN SETTING/SERIAL OUT
SETTING)
For the NETWORK BRIDGE function, send the data from the computer to the
projector with using the Network Bridge Port that is confi gured in the “Port
Settings” of web browser. (
3.1.4 Port settings – Network Bridge Port)
2 ) Using the COMMUNICATION TYPE menu, select the NETWORK BRIDGE
for the
CONTROL OUT
CONTROL OUT port. (
Operating Guide - OPTION menu -
SERVICE – COMMUNICATION – COMMUNICATION TYPE)
3) Using the COMMNICATION METHOD menu set up the proper method for the
CONTROL OUT
CONTROL OUT port, according to your use. (
Operating Guide - OPTION
menu - SERVICE – COMMUNICATION – COMMUNICATION METHOD)
• The OFF is selected for the COMMUNICATION TYPE as the default
setting.
• Using the COMMUNICATION menu, set up the communication. Remember
that an unsuitable setup could cause malfunction of communication.
• Any number between 1024 and 65535 can be set up as the Network
Bridge port number. It is set to 9717 as the default setting.
NOTE
NOTE
Item Condition
BAUD RATE 4800bps/9600bps/19200bps/38400bps
PARITY NONE/ODD/EVEN
Data length 8 bit (fi xed)
Start bit 1 bit (fi xed)
Stop bit 1 bit (fi xed)