Filter
Top Products
11
ENGLISH
Remote control
Using the LIGHT button
To illuminate the buttons of the remote control, press the
LIGHT button of it.
1.
Press the LIGHTLIGHT button.
If you don’t push the LIGHT button again, the lights will
turn off in several seconds.
Using the remote control
CAUTION ►Be careful in handling the remote control.
• Do not drop or otherwise expose the remote control to physical impact.
• Do not get the remote control wet or place it on wet objects. Doing so may
result in malfunction.
• Remove the batteries from the remote control and store them in a safe place if
you won’t be using the remote control for an extended period.
• Replace the batteries whenever the remote control starts to malfunction.
• When strong lights, such as direct sunlight or light from an extremely close
range (such as from an inverter fl uorescent lamp), hit the projector’s remote
sensor, the remote control may cause to function. Adjust the direction of the
projector to keep light from directly hitting the projector’s remote sensor.
The remote control works with the projector’s remote sensor.
• The range of the remote sensor is 3 meters with
a 60- degree range (30 degrees to the left and
right of the remote sensor).
• Also a remote signal refl ected in the screen etc.
may be available. If it is diffi cult to send a remote
signal to the sensor directly, please try.
• Since the remote control uses infrared light
to send signals to the projector (Class1 LED),
be sure to use the remote control in an area
free from obstacles that could block the remote
control’s output signal to the projector.
LIGHT
button
approximately
3 meters
30º
30º
POWER LIGHT
OPT BLK
ASPECT
MENU
BRIGHT CONTRAST COLOR
IRIS
MODE
MEMORY
ENTER
RESET
DVI PC
AUTO