Filter
Top Products
37
1) Enter the following information that is set in the projector. *1
Direct connection between the projector and PC (AdHoc mode)
3. Using the Live Mode
3.4 Passcode connection (continued)
SSID *2: wireless (example)
Encryption: WEP64bit (example)
Encryption key *3:
**********
(example)
Subnet mask *4: 255.255.255.128
(example)
After you input the Passcode (34), you are required to input the network setting
manually if you use any encryption code or your unique SSID or Subnet mask
except Class A/B/C. (32)
If you use the wired LAN, go to (40).
3.4.3 Conguring manually
• Direct connection between the projector and PC (AdHoc mode)
• The projector connected to an access point by a LAN cable
• The projector connected to an access point by the wireless LAN
Wireless LAN
2) Click [Connect].
3) The wireless connection will be established.
Proceed to the item 3.6 Conrm the
connection to your destination. (50)
*1 To nd the network setting on the projector, refer to the NOTE. (40)
*2 If you don’t use the factory default SSID, you need to set your SSID by either
entering manually or selecting from the list of detected SSID.
*3 If you use an encryption, you need to set it. Contact the network administrator
to nd the encryption key that is set in the projector.
The encryption key is always shown as “
**********
”.
*4 If you use Subnet mask except Class A/B/C, please set it.
The required information depends on how you connect the projector and PC.