Honeywell 7800 Tablet User Manual


 
14 - 3
Power
The charger must be connected to a power
source via the Honeywell power adapter cable so
that voltage is adjusted appropriately. Use only a
UL listed power supply, which has been qualified
by Honeywell with output rated at 12VDC and
3 amps with the device.
1. Plug the AC power cord into the power
adapter.
2. Plug the power cable into the power
connector on the back of the charger.
3. Plug the AC power cord into a grounded
power source.
4. The power LED illuminates green, and the
charger performs a self-diagnostic test that
lasts approximately five seconds.
Recommendations for Storing Batteries
To maintain top performance from batteries, avoid storing batteries outside of the following temperature
ranges:
14°F to 113°F (-10°C to +45°C) for short term storage of less than one month
32°F to 86°F (-0°C to +30°C) for long term storage
Do not store batteries in extremely high humidity. For prolonged storage, do not keep batteries stored in
a charger that is connected to a power source.
Inserting and Charging Batteries
For best results, battery packs should be at room temperature before recharging them; temperature has
a marked effect on charging. The recommended temperature range is 50°F to 95° F (10°C to 35° C).
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery may result in
damage not covered by the warranty.
1. Connect power to the charger, see Power above.
2. Insert the battery at an angle.
Note: Align the battery contacts with the contacts inside the
QuadCharger battery well.
3. Snap the battery into place with a hinging motion.
4. The Status LED for that particular slot illuminates
orange to indicate the battery is seated properly and
the charging cycle has begun.
5. When the Status LED turns green, the battery in the slot has completed charging.
Power Supply
Connector
Power LED
AC Power Cord
Power Cable
Power
Adapter
!
!
3
2