Filter
Top Products
BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
EN1B-0198GE51 R0801 29
If this is the very first run of the device, then the
Copyright notice is followed by the query for the
root user password. At the Old password:
prompt just hit the Enter-Key.
Once a password has been defined the BNA prints
the information User 'root' logged in. for
all future startups.
The root user is the administration user with
unlimited access rights. The root user will be logged
in automatically without any login procedure when
connecting to the BNA device via the serial link
(RS232). Any connection to the BNA via LAN is
password protected!
If the device already contains an application
firmware, then it is necessary to put the device into
the Stay in Bootloader Mode prior to the setup
activity (refer to chapter 6.3 Switching the Operating
Mode on Page 25 how this can be done).
To prepare the BNA device to operate on the LAN
and to load the application firmware into the
device, the following mandatory commands must
be executed in the order they are listed (for a
detailed command description, refer to chapter
6.5 Command Description on Page 31):
np Basic network parameters
Definition of IP address, network mask
and default gateway. These definitions
are required to allow the BNA device to
operate on the LAN.